Drill Rewrite problem
Moderator:PywareTechSupport
Is there a way to re-smooth out the animation at spots are removed from the drill using the Drill Rewrite function?
-
- Site Admin
- Posts:139
- Joined:Fri Aug 19, 2005 1:00 pm
- Location:Texas
- Contact:
Drill Rewrite problem
Hi Dustin:
1. Some of the rewritten sections continue to move after the other sections have clearly stopped.
2. A form that moves into straight-line form via a zig-zag pattern now displays all mixed up. Basically, the transition paths are now all screwed up. The beginning and ending points are fine.
1. Some of the rewritten sections continue to move after the other sections have clearly stopped.
2. A form that moves into straight-line form via a zig-zag pattern now displays all mixed up. Basically, the transition paths are now all screwed up. The beginning and ending points are fine.
-
- Site Admin
- Posts:139
- Joined:Fri Aug 19, 2005 1:00 pm
- Location:Texas
- Contact:
The drill rewrite function will not rewrite FTL paths or paths specified by the track tool. If you are needing to modify the drill by removing performers that have non-straightline paths then you will need to manually remove the performers.
Also if you have a marked time in a section that is not set off by a page tab the drill rewrite function will readjust the paths over the entire set. This is becuase it looks at page tabs to determine the sets. In this case you will need to place page tabs at the locations that have the marked times.
Also if you have a marked time in a section that is not set off by a page tab the drill rewrite function will readjust the paths over the entire set. This is becuase it looks at page tabs to determine the sets. In this case you will need to place page tabs at the locations that have the marked times.
Dustin Merrell
Pyware Technical Support
Pyware Technical Support